Hey there.

So... you use an ad blocker. That's cool. Sometimes we do too.


But without ad revenue, we wouldn't even be here. And we might not be here much longer.

Please disable your ad blocker and click to continue.

  1. #1
    SonicASD Guest

    PS3 on 3.55 OFW help?

    I just picked up my PS3 from a downgrade service and I don't honestly know where to go from here.

    The PS3 is a CECHG01 on 3.55 OFW. I would appreciate it if someone could give me some suggestions on where to go next.

    Thanks again.

  2. #2
    windrider42 Guest
    From there you would install a 3.55 CFW and make sure to qa flag it or check with Button combo on Network settings to make sure it is, in case the Downgrade service didn't do that.

    From 3.55 CFW you can install any CFW you wish, for example Rogero 4.41, Rebug Lite 4.41.1

  3. #3
    joffe Guest
    I would go with Rogero 4.41 with latest multiman, for me it gives good opportunities for homebrew, resigned packages should not be a problem, help is great here and this is close to OFW.

  4. #4
    racer0018 Guest
    I would have to disagree with the rogero I have had a lot of problems with this so I would go with rebug 4.41 lite if it were me. Thanks.

  5. #5
    JeoWay Guest
    I recommend toggling QA and install Rebug Lite 4.X

  6. #6
    Azrial Guest
    Another vote for Rebug from me too.

  7. #7
    dyceast Guest
    +1 on Rebug.

    So the specific steps for you would be

    Update Firmware to rebug 3.55.4
    Install Rebug toolbox [Its in install packages - hard drive]
    Enable Q/A [Option far right in Toolbox]
    Then update to rebug 4.41 lite

  8. #8
    racer0018 Guest
    Is this one that I did. Also on a side note if it is ofw 3.55 it is already q&a cause if it was the system would brick so don't do it again.

  9. #9
    dyceast Guest
    My mates ps3 went from 3.55 OFW and then 3.55 KMEAW, And then I just updated him to 4.xx, and he didn't have QA enabled?

    I then downgraded back to 3.55 to re-enable it, and it didn't brick?

  10. #10
    racer0018 Guest
    It doesn't brick when going down to 3.55.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Log in