How compile psgroove for Pic 18f26J50? This chip seems to be a nice upgrade to the more common USB-capable 18F4550. The 18F46J50 has 64 Kbytes of programming memory compared to 32 Kbytes of the 18F4550.

I managed to load the HID bootloader, but I could not run the psgroove. Can you help me?
     #pragma config PLLDIV = 5           //Divide by 3 (12 MHz oscillator input)
     #pragma config CPUDIV = OSC1        //No CPU system clock divide
     #pragma config OSC = HSPLL          //HS oscillator, PLL enabled, HSPLL used by USB

     #pragma config PLLDIV = 2           //Divide by 2 (8 MHz oscillator input)
     #pragma config CPUDIV = OSC2_PLL2   //CPU system clock divide by 2
     #pragma config OSC = INTOSCPLL      //internal oscillator, PLL enabled, PLL used by USB

        #error No USB_SPEED_OPTION defined, see "usb_config.h"
     #pragma config WDTEN = OFF          //WDT disabled (enabled by SWDTEN bit)
     #pragma config STVREN = ON            //stack overflow/underflow reset enabled
     #pragma config XINST = OFF          //Extended instruction set disabled
     #pragma config CP0 = OFF            //Program memory is not code-protected
     #pragma config T1DIG = OFF          //Sec Osc clock source may not be selected, unless T1OSCEN = 1
     #pragma config LPT1OSC = OFF        //high power Timer1 mode
     #pragma config FCMEN = OFF          //Fail-Safe Clock Monitor disabled
     #pragma config IESO = OFF           //Two-Speed Start-up disabled
     #pragma config WDTPS = 32768        //1:32768
     #pragma config DSWDTOSC = INTOSCREF //DSWDT uses INTOSC/INTRC as clock
     #pragma config RTCOSC = T1OSCREF    //RTCC uses T1OSC/T1CKI as clock
     #pragma config DSBOREN = OFF        //Zero-Power BOR disabled in Deep Sleep
     #pragma config DSWDTEN = OFF        //Disabled
     #pragma config DSWDTPS = 8192       //1:8,192 (8.5 seconds)
     #pragma config IOL1WAY = OFF        //IOLOCK bit can be set and cleared
     #pragma config MSSP7B_EN = MSK7     //7 Bit address masking
     #pragma config WPFP = PAGE_1        //Write Protect Program Flash Page 0
     #pragma config WPEND = PAGE_0       //Start protection at page 0
     #pragma config WPCFG = OFF          //Write/Erase last page protect Disabled
     #pragma config WPDIS = OFF          //WPFP[5:0], WPEND, and WPCFG bits ignored
is that correct?