Results 1 to 3 of 3

Thread: Found a Board for Jailbreak, will this one work?

  1. #1
    Dadfdon Guest

    Found a Board for Jailbreak, will this one work?

    Itīs a AVR USB AT90USB162 Microcontroller Prototype Board with USB


    * AT90USB162 microcontroller with 16KB Flash, 512B RAM, 512B EEPROM
    * ICSP 5x2 pin connector for in-circuit programming with AVR-ISP-MK2 (you generally don't need to use ICSP as you can program via USB)
    * Debug Wire could be performed by 3 wires connected to ICSP (AT-JTAGICE-MK2 have such lose wire connector which to be used, you need VCC, GND, RST signals only)
    * USB 2.0 Full speed connector
    * user button BUT (can be used to enter bootloader mode after reset)
    * reset button RST
    * takes power from USB no need for external adapter
    * external power supply and voltage regulator if USB can't provide enough power
    * Quartz crystall oscilator circuit 8Mhz
    * extension pin headers for each uC pin
    * four mounting holes 3.3 mm (0.13")
    * Grid 100 mils
    * GND bus
    * Vcc bus
    * FR-4, 1.5 mm (0,062"), green soldermask, white silkscreen component print
    * dimensions 100x80 mm (3.9x3.15")

    Almost only one i found which is still in stock. Thank you

  2. #2
    Luckluka Guest

    Thumbs Up

    Yes! Get it.. It works!

  3. #3
    Dadfdon Guest
    Thank you I +rep you

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts