To quote, roughly translated: Hello, I've been working on this project about two months now since I've gotten to work as public so that everyone can use, this tutorial is for consoles with 256MB NAND flash does not mean it does not work in 16MB in itself is changed almost the same in those with normal flash, but because even I have my fat 16mb 80GB I have not been able to neither prove nor verified.
Nougat (the phrase I owe to some forero around here that I really liked the expression):
With INFECTUS flash0.bin and we get our nand flash1.bin as in the tutorial to repair bad lukin nands do the same process until we get our dump flashfinal.bin 256MB nand we open this with a simple hex editor and look for this part editor:
"00 00 00 00 00 00 00 00 00 00 00 00 00 6F FF E0"
You will see that just under a very similar line, I find this data in the offset 000C0020 may vary according to the nand and the party starts here
EVEN replace that line with the file if you use the hxd 1patchcos.bin get in the first 0 of the line -> right click and paste, writing before you have to have an open 1patchcos.bin hxd in hex and copy its contents to can paste.. then we find the second file to patch at hxd we dump on our part:
Then we take the option we use reescramble flowrebuilder this dump so we rebuild our flash0.ECC.bin and flash1.ECC.bin and flash the result, when you finish you will notice that the PS3 now has a nice on but black screen, it cojemos our factory jig to put it into service mode and put it in factory, then the typical cojemos lv2diag of yore and the pup you please.
(NOTE: the first pup that metais will stay in the console as the minimum version that you can downgrade then, if you want to lose 3.55 to 3.41 then you will have to put the pup up to 3.41 before 3.55 or 3.55 will remain in that if cost will not rewrite the dump again to downgrade to lower the pup that you put the first time.)
Then you put your factory lv2diag to leave the service and you're
Note: this applies to repair the brick Waninkoko NAND not plates even sem-001 (tested) (and step downgrade )
All channel # irc-hispano darkps3 for supporting me for so long
To donate the INFECTUS austaquio32 to achieve to continue with my project
To Nodial2ne paid for the help locating files in the nand
To robs1 for helping throughout the process with ideas to make this possible
And everyone who was patient and not by private haunts me
er_poty: I do post, post it comes to creating private fights and telling him to send me get to the bottom of the shoes PDNKED
pd: I have 4 years unemployed, who selflessly want to donate something please contact me via private (sorry but I have 2 children and the PS3 does not give me to eat me or them ) either that or give me a job lene!
I wouldn't want to risk it myself... The Infectus is quite a task for average users to solder (CJPC was able to do it, but I wouldn't attempt one) and most probably don't own the hardware so you'd have to buy it and then hope you don't mess up the PS3 installing it hehe.
While this is good news for the skilled techs out there, for the rest I'd say getting a used PS3 with lower Firmware is easier.
Oh yeah - soldering all of those wires can be quite "fun", it should only be for the experienced user, if you think you want to give it a go - buy a broken board off ebay, and try soldering the 32 or so wires to it, if you did a good job, then give it an actual try. Then again, if your PS3 is bricked, you really have nothing to lose!