Hi to all, today i'm gonna share with you my second and excellent Mod for cooling and breath your PS3 100% more from the default station. To tell you the truth i took an idea from Moneymaker guide (Fixing YLOD on PS3).
While i watching his guide i saw the picture (pic1) and i said this Mod is good for PS3 Air colling and i change a little bit like u see in my guide why Moneymaker's PS3 from back was with a big hole and that i believe was dangerous for PS3, and in the and when your gonna do this guide in ur house and finished pull your hand in the back of your ps3 there you gonna make the holes you gonna be excited like me on how Cool Air the PS3 Fan sucks and the system isn't getting hold like from default it!!!
So lets go and good luck to everyone who try this at home!!!
1- I took a drill and i draw some holes above on the ps3 fan so i could see it in the plastic of ps3 and then i make the holes like u see in pic 2, make sure you do many and big holes like mine pic 3.
2- I put above the holes a Min to hold the dust to get inside to the system see pic 4.
3- Then i built again and i tested,the results was excellent!!! I wasn't believe how many air was the PS3 Fan sucked so i hope i helped with this guide and thanks to Moneymaker for his guide that i took my idea and you should try this is very easy and useful!!
To tell the truth I didn't made any guide, I've only added a comment to the one DENEGRAO wrote just pointing out that covering holes (more could have been a better idea) with something preventing dust to get inside could have been an improvement, thank him for the guide (and a little me too for the refinement ideas as well ... )
Are we sure this is a good idea? I would think some pretty in-depth engineering went into designing specific paths and routing for the airflow in these cases.
Car exhaust comes to mind. Adding huge exhaust pipes can actually hurt your car's performance and decrease horsepower. I can't help but think the intuitive "more airflow is always better" is always correct. Dunno.