12-31-2010 #11Haksam Guest
01-02-2011 #12moja Guest
Which end is 568A and B? I know the difference but to be clear to others switch the 1,3 and 2,6 pairs.
 -> 
 -> 
 -> 
 -> 
01-06-2011 #13Firmware150 Guest
My 100mbit laptop can connect directly to my PS3 with a normal ethernet just fine. I don't see the point of this in terms of the PS3 (in general it's cool I guess).
Unless using a crossover would give me a speed boost?
01-06-2011 #14Tepoo Guest
you only have to open up the end of the cable. switch the place of two of the little cables and you are finish. the only hard thing is putting the end back together. its abit uncomfortable.
im transfering mit ~50mb/s to my ps3.
01-06-2011 #15Lolzer Guest
Very lovely, i will need in the future just like everyone else
Have been lookin all over for this again thanks.
01-07-2011 #16Turk645 Guest
Personally i find it better to just buy the crimping tool and a small bag of heads. They are great to have when wire near the head snaps and you need to replace it. You can also save a butt load if you just buy one of the unheaded spools of cable and put the heads on yourself..
01-07-2011 #17lefterisk Guest
01-07-2011 #18Tepoo Guest
like i said, only switching two of the cables. nice picutres. its like one of the one i used in my school for building up them in lesson
01-13-2011 #19Hunterdog Guest
This is a easy to use tut. The video helped too.