Alternative Infectus PS3 COK-002 Solder Points Guide

[mushy409]

Hey all, it's been a while since I contributed, so here's some alternative solder points for the COK-002 Infectus install.

This method STILL requires 3 points to be soldered to the TSOP (no alts. available) but cuts down the tedious job of soldering them all to it.

For this board you will need external 3.3v power as the Infectus can't manage it. I use a Sony minidisc DC charger rated at 3.3v (3.38v DC) which powers the 2x NAND ICs perfectly.

Any questions - FIRE AWAY!!!

[Admin]

Thanks for the update mushy409 and +Rep!

[theinfinite]

What about the Progskeet v1.1 crystal blue edition, 360 clips and PCB adapters?

[cfwprophet]

What you mean with that ? For what you need alternative solder points when you have Clips to connect to the NAND's ?

[mushy409]

You're missing the point - the clips don't require ANY soldering. As for the progskeet diagrams - progskeet.com...?

[SNUBNOSEDADDY]

i have the same board but i'm having problems on reading the flash0, even with the external power, any ideas?

[xjohnpx]

I have a fiberglass pen and i tried to clean up a solder point but its green and not copper... need help please

[mushy409]

You haven't scrubbed it enough with the pen. You'll know when you're there as you'll see the bright copper underneath

[xjohnpx]

ok have i have soldered every point but d6 and d0 because it seems like thres nothing to solder to ....every other point work and has copper but these seem like there just "holes"? Is there any wayto remove the green silk screen to find the trace?

thanks mushy!!!!

[cbr600]

Hey xjohnpx... I used a dental pick to remove the green film. Worked like a charm without scraping too much